Install crDroid 12 for Pad 6

pipa

Flashing instructions


Pre-installation:

  • Download latest ROM package (rom.zip)
  • Download boot.img, dtbo.img, vendor_boot.img (links mentioned in ROM post)
  • Flash latest firmware (if not already included in ROM)
  • Optional GApps (referred to as gapps.zip).
  • Optional custom recovery (TWRP/OrangeFox)
  • Make sure bootloader is unlocked

Put all downloaded files in a single folder (recommended: platform-tools folder).


First time installation (clean flash):

  • Step 1: Reboot device into bootloader
adb reboot bootloader

(or hold Power + Volume Down while device is off)

  • Step 2: Flash required images
fastboot flash boot boot.img
fastboot flash dtbo dtbo.img
fastboot flash vendor_boot vendor_boot.img
  • Step 3: Reboot into recovery
fastboot reboot recovery
  • Step 4: In recovery, Format Data (optional if flashing over same ROM, required for first time clean install)

  • Step 5: From recovery menu → select Reboot to recovery (Advanced → Reboot to recovery)

  • Step 6: Select Apply updateApply from ADB, then sideload firmware

adb sideload firmware.zip

(replace firmware.zip with actual filename)

  • Step 7: (Optional) Reboot recovery again, select Apply updateApply from ADB, then sideload ROM package
adb sideload rom.zip

(replace rom.zip with actual filename)

  • Step 8: (If flashing Vanilla build) Reboot recovery after ROM install ends at ~47% on PC terminal, then sideload GApps:
adb sideload gapps.zip
  • Step 9: Reboot system

Update installation:

  • If you're updating to a newer version, you can either:

    • Via OTA: Use the in-built Updater. (Settings > System > Update)
    • Via Recovery: Follow Step 2 above without factory reset.
  • If Playstore is crashing after flashing rom , just reflash the gapps.zip file.

Require support?

For support questions, check out forum or telegram links found on our support page